TECWERK
Convincing quality and product variety!

Deep-hole drill DIN 1869 type TS HSS cylinder shank TECWERK

HSS · DIN 1869 · Type TS · Point angle 130° · Profile-ground with split point from Ø 2.0 mm · With straight shank · Right-hand cutting · Extra-long type · Special drill for extremely deep bores · For drilling in all long-chipping materials e.g. steel up to approx. 1,000 N/mm², aluminium alloys, Al-Si alloys, electrolytic copper, tough brass, cast iron

Deep-hole drill DIN 1869 type TS HSS-Co cylinder shank TECWERK

HSS-Co · DIN 1869 · Type TS · Point angle 130° · Profile-ground with split point · With straight shank · Right-hand cutting · Extra-long type · Special drill for extreme bore depth, with marked thermal hardness resistance and with large chip space · For boring under difficult conditions, with high thermal demand · For the processing of steels and steel castings of high strength, grey cast iron, malleable cast iron, spheroidal cast iron etc.

Demolition blade TECWERK

For craft knife · Ice-hardened

Demolition hook blade L104.5xW17.7xT0.5 mm TiN 3 rated break points 10 pc. / dispenser TECWERK

For craft knife · Ice-hardened PU = 1 safety dispenser with 10 pc.

Depth calliper gauge DIN 862 digital straight measuring rail TECWERK

Digital · Easy to read · Digit height 8 mm · The capacitive measuring system is located in the measuring rail protected against dirt and damage · Hardened rail and measuring bridge · Battery check display · For depth measurement · With straight measuring rail · With locking screw · Accuracy 0.03 mm · Reset to zero from any position · Electronics switches off automatically after 5 minutes Further technical information: · Subject to audit: Yes

Depth calliper gauge DIN 862 straight measuring rail 10 x 4.5 mm TECWERK

Straight measuring rail · With locking screw · Matt chrome-plated nonius and scale Further technical information: · Subject to audit: Yes

Dial calliper gauge DIN 862 150 mm 1 pointer revolution 1 mm TECWERK

Round scale with 1-pointer system · With micro-adjustment roller · For inner, outer and depth measurements · With locking screw Further technical information: · Subject to audit: Yes

Dial gauge 12.5 mm readout mm 0.01 digital TECWERK

Digital · 5 digit LCD display · Autom. Switch-off · On/off switches · Zero reset · External Ø 58 mm · Clamping shank (Ø 8 mm h6) Further technical information: · Subject to audit: Yes